Final sheet of Velostat taped to helmet
Place strips of tape all around the helmet to make the Velostat secure. You will use one or two platefuls of tape strips for this.
Make a final pass of tape with horizontal layers of 2 inch wide tape on the inside and the outside of the helmet.
Thought screen helmet Inside of finished "thought screen helmet" with eight sheets of Velostat shielding, 3M part number 1706. This helmet has been very successful in stopping alien abductions.Back of finished 'thought screen helmet'.
Front of finished 'thought screen helmet'. Note final layer of tape on helmet. Your helmet or whatever hat you use for a 'thought screen' should be well taped, as you will sleep in it and wear it as often as possible.

Tape over any creases or folds of Velostat on the inside of the helmet.


Add the finishing layer of tape over the sides of the hat and Velostat.


Tape any loose ends.


  1. Apply horizontal sheets of tape over the vertical strips for a final covering.

  2. Apply a layer of tape over the strips from the inside first, then a layer over the outside strips of tape second.

  3. Apply tape to any areas that need reinforcement. Remember, you will sleep with the hat on.

  4. YOUR THOUGHT SCREEN IS COMPLETE.

Although the thought screen helmet works well without a ground for most people, some people wearing the helmet report a buzzing sound.  The sound can be completely eliminated by grounding the thought screen helmet with a two wire insulated ground and two grounding rods, well connected to the velostat in the helmet.

If you have problems making the thought screen helmet, email the inventor.